Hash Mode

[iq180]

99W gone to new hashmode?

No, it has not, it's working fine as of 12:30 PM EST.

[Jim]

Thank you! They were working on my V7 and V8's but for some reason they are not now after the last update!

[iq180]

Thank you! They were working on my V7 and V8's but for some reason they are not now after the last update!

If you have done the last update put the receicer on one of the A F N CHs and then power it off and back on and let it sit there for up to 1 Hr, it should open if your EMM key is valid, if it still don't open send me a PM for a new key.

[Jim]

I have power off the receivers and powered them back on. I'm going to wait longer to see if it comes on. I will let you know.

Thanks

[Jim]

I have power off the receivers and powered them back on. I'm going to wait longer to see if it comes on. I will let you know.

Thanks

Got the problem resolved and all is good!

Thanks

[Xsat]

A F N changed Hash Mode to 30 last weekend.
However, most GTMedia DSTB are up to date
By updating F / W, we solve this problem.

[STRETCH]

Have A F N at 9e changed to a new (hash), unable to decode the channels on this sat with a V7 Plus with latest software 7 March 2019 and codes posted within the last few hours.

Den

[iq180]

Have A F N at 9e changed to a new (hash), unable to decode the channels on this sat with a V7 Plus with latest software 7 March 2019 and codes posted within the last few hours.

Den

Yep, looks like it has changed to hash mode 31.

[Eak_Dumnern]

I think same as you too.