Code FUP9

[Makle]

Anybody can help..what happen to my box..always show this code in my box

[Makle]

Please help

[Feralkiwi]

That is the factory menu page.
It will be in PAL TV format, so if your TV is NTSC only you will not see the screen.

You will need to do a forced upgrade.

Owen

[Makle]

It still happen....i already follow ur instruction..

[cpr43]

It still happen....i already follow ur instruction..

What model its?

What it is showed in the main panel of the box?? Just Up9?

[Makle]

Here the picture

[Feralkiwi]

Do you know if your TV is NTSC only or does it also do PAL?

If you have a 3.5mm 17mm long AV cable try that.

Here are my note on USB flash.bin recovery.

Owen


flash.bin recovery is done like this.

Place a copy of the unpacked software (the .bin file) on a USB stick and rename it "flash.bin"
With the USB in the unit, power on while repeat pressing "Menu" on the remote.
The unit should reload the software.

Also other users say that you must use a USB stick, not a card holder etc and that stick must be 32Gb or under.
Use the rear USB port on units that have two ports.

I have had units that will not recover.
Try using the same software as was in the unit when it crashed, not the new update software.
You must use the correct software, ie that for the V7HD for the V7HD etc, not software for any other freesat units.

Try even older software as the file for flash.bin.

Look at the LED in the USB stick. When the TV shows the message "USB Upgrade, do not turn off" you should see the LED on the USB flash as the file is loaded.
The USB LED should also flash a few times as the unit first powers on and looks at it.
Also users have said to use the rear USB port for this on V8 units.

Good luck

New information: Users are reporting that naming the file "Flash.bin" with a capital has worked where "flash.bin" has not. This is with the Nova units mostly.