Hi at all,
i made a new search on Italy LCN and now i don't find the mediaset Chanels anymore. The Transponder 11432 V 29900 is Dead. There is no Signal.
What happens? The Transponder under and over this numbers works correctly.
The Dish is on the Roof and i can't go over there.
Is there another way to find out if it is a Dish Problem or a Transponder Problem?
I have a 80 cm Dish and a V7 Pro decoder and i am in Germany
Thank you in advance
No Mediaset Chanels No signal on Transponder 11432 V 29900
Moderators: admin, GTMedia Team
Re: No Mediaset Chanels No signal on Transponder 11432 V 29900
Have checked on my (V8X)Mars receiver, here in the UK, with a 80cm dish, did find the channels on that transponder, the readings on the receiver with
the mars software is a bit lower of S92% and Q69%.
What are the readings of the other transponders, the one in question may be a bit lower, were you getting the channels before you had this issue.
Den
the mars software is a bit lower of S92% and Q69%.
What are the readings of the other transponders, the one in question may be a bit lower, were you getting the channels before you had this issue.
Den
Re: No Mediaset Chanels No signal on Transponder 11432 V 29900
Dear Stretch,
thank you for your reply.
I made a few pics where you can see what i meen.
Maybe you can see more than me.
thank you for your reply.
I made a few pics where you can see what i meen.
Maybe you can see more than me.
- Attachments
-
- IMG_20220929_172236.jpg (3.01 MiB) Viewed 426 times
-
- IMG_20220929_172124.jpg (3.58 MiB) Viewed 426 times
-
- IMG_20220929_172055.jpg (3.69 MiB) Viewed 426 times
-
- IMG_20220929_172017.jpg (3.57 MiB) Viewed 426 times
Re: No Mediaset Chanels No signal on Transponder 11432 V 29900
Set up, looks alright, have checked the signal Strength with my V8X, here i am getting 92%, you could get a bit more. Is your system a single dish or fitted with a motor.
Just make sure all connects are all ok, it could well be that the dish may have moved a little, also check the skew of the Lnb.
Den
Just make sure all connects are all ok, it could well be that the dish may have moved a little, also check the skew of the Lnb.
Den