Help V7pro Channel Search

[rock80]

Hi, I installed the MARS software on my decoder but I' m not able to receive any Channel. With the "old" software I used the "Italy LNC" search function.

Could someone help me to configure the parameters to lunch the Channel Scan?
I have an old dual Feed LNB (hotbird+Astra) with 1 coax cable exit connected.
I do not know how to set LNB1, LNB2 ( I only have One LNB)....which kind of LNB...if Universal or not...which diseq etc. I see that It asks also for low at High freq.

I'm mainly interested in Hotbird, ( I could also avoid tò configure Astra).

[STRETCH]

From what you are saying, you have a Monoblock lnb fitted.
With you saying that you only wish to view channels from 13e.
The best way forward would be to remove the (Monoblock) and fit a new single output Universal lnb, in doing this you would need to adjust your dish to receive signals from 13e, check out (Dishpointer).

Den

[rock80]

Thanks for your reply, Yes I have the LNB with 2 eyes and 1 connector that was working nice with the old software.
Could you suggest me how to configure the MARS parameters to search channels...

Thanks

[STRETCH]

When using the (search box)(Mono Block), there are threads about this set up, which is with the old software.
As yet have not found a thread about the subject with the Mars software.
Have you tried using the (Diseq 1.0) setting 13e say to LNB 1, and the other to LNB 2.
If that does not work put 13e to LNB 2 and the other to LNB 1, see what scan's in.
Other uses should see this thread and be able to help.

Den

[rock80]

Thanks! Works

[STRETCH]

Glad to hear that you are now sorted.

Den