GTMedia V7 Pro does not power up
Moderators: admin, GTMedia Team
GTMedia V7 Pro does not power up
The receiver does not have the red light when powered up. There is a tiny green light that is flashing. Is it any method to power up this receiver? Thanks!
Re: GTMedia V7 Pro does not power up
The red light should be on when the receiver is in (Standby), when you switch the receiver on, it should boot, then go to last channel viewed.
With having a flashing Green light, you need to remove the HDMI lead, switch off the receiver at the rear.
Leave for a couple of minutes, put the HDMI lead back in, then switch back on, should then Boot etc.
Den
With having a flashing Green light, you need to remove the HDMI lead, switch off the receiver at the rear.
Leave for a couple of minutes, put the HDMI lead back in, then switch back on, should then Boot etc.
Den
Re: GTMedia V7 Pro does not power up
A flashing green light may be a power supply issue or a LNB cable fault.
Try power on with all disconnected.
Try another power supply.
If powers on to just steady green led, do a forced recovery.
Owen
Try power on with all disconnected.
Try another power supply.
If powers on to just steady green led, do a forced recovery.
Owen
Dishes; 3x3m, 2.4m and 4.1m, 10+ ku, 2 movers, USARLS. V8 Combo, Pro, V8 Golden, Nova V8Pro2, GTC, Super.V7HDs, Combo and V7s V7Plus Finder, Finder-Meter V8X / UHD V7Pro GT/XCombo. Sats 100.5E to 177W. I'm a Sat hobbyist who helps out.