Remove auto standby

[maesonet]

Good afternoon, due to an error I have activated in the system menu, other settings, I have activated the auto standby and now I turn on the deco but it only goes to standby.

I cannot enter the menu again. The tv screen is always black and the deco after the chec goes to standby.
Does anyone know how to disable the auto standby function. thanks

[cpr43]

Good afternoon, due to an error I have activated in the system menu, other settings, I have activated the auto standby and now I turn on the deco but it only goes to standby.

I cannot enter the menu again. The tv screen is always black and the deco after the chec goes to standby.
Does anyone know how to disable the auto standby function. thanks

Look for the latest firmware for your box and do an USB flash.bin recovery process:

Here are some instructions from feralkiwi:

flash.bin recovery is done like this.

Place a copy of the unpacked software (the .bin file) on a USB stick and rename it "flash.bin"
With the USB in the unit, power on while repeat pressing "Menu" on the remote. You must use the V7 remote on the V7.
The unit should reload the software.

Also other users say that you must use a USB stick, not a card holder etc and that stick must be 32Gb or under.
Use the rear USB port on units that have two ports.

I have had units that will not recover.
Try using the same software as was in the unit when it crashed, not the new update software.
You must use the correct software, ie that for the V7HD for the V7HD etc, not software for any other freesat units.

Try even older software as the file for flash.bin.

Look at the LED in the USB stick. When the TV shows the message "USB Upgrade, do not turn off" you should see the LED on the USB flash as the file is loaded.
The USB LED should also flash a few times as the unit first powers on and looks at it.
Also users have said to use the rear USB port for this on V8 units.

[maesonet]

Thank you so much for everything