the V8 Turbo had a bug while it was running.
After the bug it rebooted, but it still stops at LO96,
The remote control and the buttons on the front of the V8 Turbo have no action.
I unplugged the V8 Turbo, after a few minutes I plugged it back in, still the same problem boot then load until LO96 and nothing.
On the TV it says "GTMedia" for a short while and then "no signal".
Is there any way to get it working again?
after a bug V8 turbo stops at LO96
Moderators: admin, GTMedia Team
after a bug V8 turbo stops at LO96
V8 Turbo ;
Re: after a bug V8 turbo stops at LO96
You may have to do a (Force) download of the software, name the file (flash.bin), the last update to this receiver was V303 15 Dec 2021.
Den
Den
Re: after a bug V8 turbo stops at LO96
I did like this.
_V8 Turbo disconnected
_USB with flash.bin .
reconnect the V8Turbo and continuously press "menu" on the receiver
and not on the remote control otherwise it does not work.
after FUP9,
USB upgrade! do not power off!
2 minute wait
it worked .
thank you
_V8 Turbo disconnected
_USB with flash.bin .
reconnect the V8Turbo and continuously press "menu" on the receiver
and not on the remote control otherwise it does not work.
after FUP9,
USB upgrade! do not power off!
2 minute wait
it worked .
thank you
V8 Turbo ;
Re: after a bug V8 turbo stops at LO96
Glad to hear that you are now sorted.
Den
Den
Re: after a bug V8 turbo stops at LO96
Exelente información yo tengo este mismo equipo nuevo no le e actualizado ,pero tendré que acerlo luego siempre existe el temor de que algo salga mal es bueno saber que se puede resusitar de manera forzada gracias por la información
Re: after a bug V8 turbo stops at LO96
Yes I have noted that the instruction say "continuously".stephan94 wrote: ↑Thu Mar 03, 2022 7:35 pmI did like this.
_V8 Turbo disconnected
_USB with flash.bin .
reconnect the V8Turbo and continuously press "menu" on the receiver
and not on the remote control otherwise it does not work.
after FUP9,
USB upgrade! do not power off!
2 minute wait
it worked .
thank you
That may be why you need to use the button on the front panel.
Owen
From the PDF file for the V7 V8.
6. V7 V8 USB forced upgrade:::
6.1. Connect the power, and press “MENU” continuously with the remote control.
Note: Press the button continuously.
This should read repeatedly"
6.2.Digital tube shows UP9,,,After releasing the MENU button, enter the upgrade mode
Dishes; 3x3m, 2.4m and 4.1m, 10+ ku, 2 movers, USARLS. V8 Combo, Pro, V8 Golden, Nova V8Pro2, GTC, Super.V7HDs, Combo and V7s V7Plus Finder, Finder-Meter V8X / UHD V7Pro GT/XCombo. Sats 100.5E to 177W. I'm a Sat hobbyist who helps out.