Hi, I did a clean install of the Mars from the original GTMedia v8x firmware, and a channel scan from 0 with it. Everything works perfectly, but after 2-3 minutes, no more, the Decoder freezes and you have to turn it off from the back button.
HW Version 1.1.3
SW Version 1.10.5376
What can I do?
V8X freezes after few minutes
Moderators: admin, GTMedia Team
Re: V8X freezes after few minutes
How are you decoding your channels, if it is via ccam, check your network, contact your supplier.
Den
Den
Re: V8X freezes after few minutes
Is via new media go dot com, it isnt cccam, is it?
Re: V8X freezes after few minutes
Hello again,
I have detected a curious thing. If I do a factory reset of channels only and load the list of channels that you post in this forum in the download area, the operation is 100% perfect, and does not hang even in a few hours of viewing.
However, if I put it in Standby only once, the next time I turn it on, after 2-3 minutes it is completely frozen, not responding to anything, except to turn it off from the back button.
Has anything similar happened to any of you?
I have detected a curious thing. If I do a factory reset of channels only and load the list of channels that you post in this forum in the download area, the operation is 100% perfect, and does not hang even in a few hours of viewing.
However, if I put it in Standby only once, the next time I turn it on, after 2-3 minutes it is completely frozen, not responding to anything, except to turn it off from the back button.
Has anything similar happened to any of you?