GTC Standby Bug

[ak_273]

Dear developers...i was set by Suspend and Resume..so if i press power to standby, it is automatically to red light and display indicator was off..but if turn on it shows green light only and display indicator was not turn on...and at TV shows no signal...

I hope it would be fixed soon

[ak_273]

This full image of this problem

[nzl229]

Please pull out the HDMI cable and plug it back in to see if there is any display.

[ak_273]

Nothing happen bro... :'( ...but after show like that about 4 minutes, it was going to "boot"

[Captain Ron]

It might be your photos but I can't help but notice your green light looks very dim, I just got my GTC last week and it has the clear plastic over the lens (like you do) and my green light is very bright compared to what I see in your photos.

Mine goes to standby when I shut it down (its set to do that) and it has a red light only, when I turn it on the light turns green and clock comes on as it should so you may have a power issue. I would try a power reboot (pull the cord) for about 30 seconds and I would also try a different HDMI cord unless you have used it on another receiver and you know its good.

I noticed in the settings that you can have your GTC go to either standby when you shut it off (normal setting) or you can elect to have it do a real shut down when you shut it off. (Mine came with going to Standby as being what it does as normal when I shut it down so yours probably is also so its going to standby is normal.)

Other than the navigation being a bit quirky my GTC is working great, watched NASA on it last night for a little while.

I just don't have any keys for it.

Good Luck !

[juan_vale]

I just don't have any keys for it.

PM sent