Page 1 of 1

113W Blind Scan

Posted: Sun Jun 09, 2019 12:59 pm
by Hank4
I updated my box to GTC_OTA_C20.A6.2.46_20190604 and did a factory reset. Since I use a DiSEqC 1.0 switch, I set it to port 2 where my C-Band signal is connected. I scanned 113W several times before I was able to acquire any channels. My final scan was Scan Mode–Blind, Cryted-All, Accurate Scan-ON. I got FTA channels only and did not get any of the encrypted channels that I normally get on my Super 8 and Nova. I’m interested in getting the PowerVu channels on transponder 4140H such as Canal Once and Canal 22. In addition, I would like update my softcam to receive these channels. Your help will be appreciated.
Thanks, Hank

Re: 113W Blind Scan

Posted: Sun Jun 09, 2019 1:46 pm
by cpr43
Scan Mode: BlindScan
Crypted: All
Service Type: All
Accurate Scan (Off/On) as you wish
Yes

Try also, to choose Diseqc 1.0 port 1 even if you are connected to port 2 and test

Re: 113W Blind Scan

Posted: Wed Jun 12, 2019 6:04 am
by msilver511
PM sent Good Luck!

Re: 113W Blind Scan

Posted: Wed Jun 12, 2019 12:21 pm
by Hank4
msilver511 wrote:
Wed Jun 12, 2019 6:04 am
PM sent Good Luck!
Thank you very much for sharing.
Hank :D :D

Re: 113W Blind Scan

Posted: Mon Jun 24, 2019 1:13 pm
by Hank4
cpr43 wrote:
Sun Jun 09, 2019 1:46 pm
Scan Mode: BlindScan
Crypted: All
Service Type: All
Accurate Scan (Off/On) as you wish
Yes

Try also, to choose Diseqc 1.0 port 1 even if you are connected to port 2 and test
I’ve scanned 113W numerous times using all available options and I’m still not getting any of the encrypted channels. Is anyone out there getting any of these channels? Will appreciate your feedback.
Thanks, Hank