Hi,
Using new firmware ' C20.A9.1.11' after setting factory defaults, I have this problem:
I go to multiscan instalation menú, set up 4 sats (70W ku, 58W C, 55W C, 30W ku), select them to do a manual scan.
The problem is that after pressing the red botton to scan, only one SAT is scanned at the time, not all 4 as it used to do it.
regards,
Johan
Multi Sat Scan
Moderators: admin, nzl229, GTMedia Team
-
- Posts: 97
- Joined: Mon Jul 02, 2018 4:24 pm
- Location: Costa Rica
Re: Multi Sat Scan
Issue continues with version:
Date: 2021.11.19
Software version: C20.A9.1.12
No matter how many Sats in the list you select, only one get scanned.
regards,
Johan
Date: 2021.11.19
Software version: C20.A9.1.12
No matter how many Sats in the list you select, only one get scanned.
regards,
Johan
Re: Multi Sat Scan
what is the device type do you use with the 4 satellites, such diseqc or motor?
-
- Posts: 97
- Joined: Mon Jul 02, 2018 4:24 pm
- Location: Costa Rica
Re: Multi Sat Scan
Hi Tom,
I'm using Diseqc switch:
1. 70w - Ku - Diseqc 1.0: port 2, Diseqc 1.1: port 1
2. 58w - C - Diseqc 1.0: port 1, Diseqc 1.1: port 1
3. 55w - C - Diseqc 1.0: port 3, Diseqc 1.1: port 2
4. 30w - C - Diseqc 1.0: port 4, Diseqc 1.1: port 2
regards,
Johan
Re: Multi Sat Scan
If you only have 4 satellites, you only need to use (diseq 1.0).
Den
Den
-
- Posts: 97
- Joined: Mon Jul 02, 2018 4:24 pm
- Location: Costa Rica
Re: Multi Sat Scan
As you say, if you use more than four satellites, yes, (diseq 1.1) is to be used.
Den
Den
-
- Posts: 97
- Joined: Mon Jul 02, 2018 4:24 pm
- Location: Costa Rica
Re: Multi Sat Scan
Yes,
But that is not may issue!
All sats works fine with my settings.
The function to scan all with just one command is not working, I have to scan one at a time.
Regards,
Johan