Bug appears on all existing firmware, and is as follows. If the antenna power is turned on in the DVB Player settings, when an antenna powered by an antenna cable is connected to the dvtb2 input, everything works. But if you turn off or restart the GT COMBO, the antenna power is turned off, and DVB Player writes "No signal". But if you go to the DVB Player settings, -> antenna power and change the setting to "off", and after "on", the antenna power is restored and the signal from the antenna appears, and with it the ability to view dvtb2 channels. The situation repeats itself with each reboot, shutdown: The power supply of the dvtb2 antenna after a reboot, turning off the set-top box each time you have to turn it on manually in the DVB Player settings.
Bug проявляется на всех существующих прошивках, и заключается в следующем. Если в настройках DVB Player питание антенны включено, когда на вход dvtb2 подключена антенна с питанием по антенному кабелю все работает. Но если выключить или перезагрузить приставку GT COMBO, питание антенны выключается, и DVB Player пишет "Нет сигнала". Но если зайти в настройки DVB Player, -> питание антенны и изменить настройку на "выключено", а после "включено", питание антенны восстанавливается и появляется сигнал с антенны, а с ним и возможность просмотра dvtb2 каналов. Ситуация повторяется при каждой перезагрузки, выключении : Питание антенны dvtb2 после перезагрузки, выключения приставки каждый раз приходится включать в ручную в настройках DVB Player
GTCombo Box Bug DVB Player bug antenna power not signal
Moderators: admin, nzl229, GTMedia Team
GTCombo Box Bug DVB Player bug antenna power not signal
- Attachments
-
- AndroVid_8462.zip
- Demonstration Bug DVB Player antenna power
- (9.73 MiB) Downloaded 16 times