GTMEDIA Forum

Hi,
Does anyone use this tuner with DVB-T2 and DVB-S2 antennas connected? How to properly perform a channel scan?
First, a scan is performed of the DVB-T antennas and then the satellite?
When I did this, the satellite scan overwrote the DVB-T channels.
When I changed the order, it saved DVB-T channels, probably at the end of the list, but I cannot select or enter them.
When you try to sort the channels, it also moves some and not some.
When selecting DVB-T/DVB-S channels, do I need to switch the receiver/antenna somehow?

How to add these channels to be able to switch freely between terrestrial television and satellite?

Regards
Kris

Just check this out, which may help.
Press OK, on the remote, which should bring up the channel list, if you were on a satellite channel last, ie Music Channel which is on 1w, move the curser to the left, will now be on (0.8w Ku-band Thor5/), move the curser Down to (FTA), which should bring up your (DVB-T2) channel list, then move the curser over to the right, then move to the channel required, then press OK.
Try this and see what happens, then we will move onto the next issue.

Den

The option for new channel list in settings if set to yes, the channel list does not show the selection of other satellites UNTIL you press left arrow.

Owen

Hi, thank You for Your help . Now it's clear for me and works as expected.
It will be good Idea to add information to user manual how channel lists work.

Regards
Kris

Glad to hear that you are now sorted.

Den