I just got my GTC today. It's not been fun. I could not get the box to work with my motor control.
Now it will move it east and west. But I set the position. And hit OK. And nothing. Soon as I back to out. It goes back to 1.
How do I fix this problem. There is no save. And no position button.
Zach
Motor control problems
Moderators: admin, nzl229, GTMedia Team
Motor control problems
- Attachments
-
- IMG_20180207_230643.jpg (3.08 MiB) Viewed 1960 times
Re: Motor control problems
Yes as far as I know there is no support for USALS yet.
I also have big problems with DiSEqC switching. The GTC does not do 1.0 and 1.1 switching corretcly with cascade switching.
I have great difficulty using my GTC on my DiSEqC network, an 8 port switch and then many 4 port switches.
Owen
I also have big problems with DiSEqC switching. The GTC does not do 1.0 and 1.1 switching corretcly with cascade switching.
I have great difficulty using my GTC on my DiSEqC network, an 8 port switch and then many 4 port switches.
Owen
Dishes; 3x3m, 2.4m and 4.1m, 10+ ku, 2 movers, USARLS. V8 Combo, Pro, V8 Golden, Nova V8Pro2, GTC, Super.V7HDs, Combo and V7s V7Plus Finder, Finder-Meter V8X / UHD V7Pro GT/XCombo. Sats 100.5E to 177W. I'm a Sat hobbyist who helps out.
Re: Motor control problems
The motor problem is fixed now. The update is what fixed it. 19e
-
- Posts: 15
- Joined: Thu Mar 08, 2018 6:18 pm
Re: Motor control problems
I recently purchased A a GTC and I also can’t get it to work with my satellite mover or I cannot get it to tune in to any satellites that I know of. Any information or advice that you can forward to me would be wonderful. Thank you for your time
Re: Motor control problems
I use a Satellite Positioner with DiSEqC 1.2 motor commands, my V8 Super, V8 Nova and V8 Pro2 work perfectly my GTC box has never worked. With the GTC I have to move the dish separately.