Please have a look at this post on UP9.
Owen
Moderators: admin, GTMedia Team
Are you saying that your serial number is xxxxxx?
4: If the SN number displayed is XXXXX after the software is up, and the SN number displayed is XXXXX, please tell us the original SN number of the box, and we will provide the software to burn the SN number.
Where should this SN number be displayed? at what time and place? I only have the number on the housing that I gave earlier.4: If the SN number displayed is XXXXX after the software is up, and the SN number displayed is XXXXX, please tell us the original SN number of the box, and we will provide the software to burn the SN number.
I cannot enter the menu because the UP9 error does not allow it. The decoder does not react to the operation of the remote control at all. I understand that the trash decoder?STRETCH wrote: ↑Wed Aug 10, 2022 4:18 pmIf it is like any other GTMedia receiver, you should find the s/no within the (Information) of the receiver.
Press Menu on the remote, and go through each one in turn, (it could be within (Tools)), until you see the word (Information), Press OK, this should then show what your model is/serial no/hw version/sw version etc.
Den
From the PDF file for the V7 V8.
6. V7 V8 USB forced upgrade:::
6.1. Connect the power, and press “MENU” continuously with the remote control.
Note: Press the button continuously.
This should read repeatedly"
6.2.Digital tube shows UP9,,,After releasing the MENU button, enter the upgrade mode