v73 Мультистрим и шкала уровня и качества сигнала
Posted: Sun Jun 02, 2019 8:40 am
Сегодня получил свой прибор, он мне очень понравился! Сразу бросился в глаза дисплей, по сравнению с v71 владельцем которого я тоже являюсь, он очень яркий, это очень хорошо. Далее обнаружил, что прибор видит сигнал ZeonBud с Astra 4.8e, но сканирует только один транспондер 12341 H DVB-S2 multistream stream 40, на 12188 H DVB-S2 multistream stream 10,20 и 12341 H DVB-S2 multistream stream 30, при сканировании каналов не находит. Далее, шкала уровня и качества сигнала осталась как и на v71 - маленькая, это очень плохо, ведь это-же прибор для настройки, а не домашний спутниковый ресивер, с моим 100% зрением нужно вглядываться в шкалу, это никуда не годится. Beep работает только в режиме настройки, в режиме Info он не работает, хотя при нажатии кнопки "Beep" на экране появляется информация Beep On/Off, возможно разработчиками так и было задумано, хотя логика не ясна.
Просьба к разработчикам (Самое основное!) - Сделайте большую шкалу по кнопке "Info"!!! Все остальное второстепенное, хотя тоже нужное!
Google Translate:
Today I received my device, I really liked it! Immediately struck the display, compared with the v71 owner of which I am also, it is very bright, it is very good. Then I discovered that the device sees a ZeonBud signal with Astra 4.8e, but only scans one transponder 12341 H DVB-S2 multistream stream 40, at 12188 H DVB-S2 multistream stream 10, 20 and 12341 H DVB-S2 multistream stream 30, while scanning Channels does not find. Further, the scale of the level and quality of the signal remained the same as on the v71 - small, this is very bad, because it is the same tuning device, not a home satellite receiver, with my 100% vision you need to peer into the scale, it is no good. Beep works only in setup mode, in Info mode it does not work, although when you press the "Beep" button, Beep On / Off information appears on the screen, it was possible that the developers intended it, although the logic is not clear.
Request to the developers (The most basic!) - Make a large scale on the button "Info" !!! Everything else is secondary, though also necessary!
С уважением!
Respectfully!
Просьба к разработчикам (Самое основное!) - Сделайте большую шкалу по кнопке "Info"!!! Все остальное второстепенное, хотя тоже нужное!
Google Translate:
Today I received my device, I really liked it! Immediately struck the display, compared with the v71 owner of which I am also, it is very bright, it is very good. Then I discovered that the device sees a ZeonBud signal with Astra 4.8e, but only scans one transponder 12341 H DVB-S2 multistream stream 40, at 12188 H DVB-S2 multistream stream 10, 20 and 12341 H DVB-S2 multistream stream 30, while scanning Channels does not find. Further, the scale of the level and quality of the signal remained the same as on the v71 - small, this is very bad, because it is the same tuning device, not a home satellite receiver, with my 100% vision you need to peer into the scale, it is no good. Beep works only in setup mode, in Info mode it does not work, although when you press the "Beep" button, Beep On / Off information appears on the screen, it was possible that the developers intended it, although the logic is not clear.
Request to the developers (The most basic!) - Make a large scale on the button "Info" !!! Everything else is secondary, though also necessary!
С уважением!
Respectfully!