GTMedia V8 Finder Pro 2 on TechniSat TechniRouter 5/1x8 K
Posted: Mon Jan 22, 2024 6:07 pm
Hello,
I've been trying to connect this satellite finder to the TechniSat TechniRouter 5/1x8 K for some time now. Unfortunately, I'm having difficulty navigating the settings page under the Satellite section. I've set it to Unicable A for LNB Frequency, Channel Frequency at 12.750, and Frequency also at 12.750. Symbol Rate is 20.000, Polarization is Horizontal (H), IF Channel is 1, and for the Center Frequency, I've entered the highest among 8 channels at 2096 megahertz. I've also tried 1284 megahertz, which corresponds to Channel 1, but I'm unsure about what to enter on this page. I'm not receiving any signal, and everything is properly connected and wired. Additionally, it's worth noting that the TechniRouter uses a Sat-CR single-cable solution.
I've been trying to connect this satellite finder to the TechniSat TechniRouter 5/1x8 K for some time now. Unfortunately, I'm having difficulty navigating the settings page under the Satellite section. I've set it to Unicable A for LNB Frequency, Channel Frequency at 12.750, and Frequency also at 12.750. Symbol Rate is 20.000, Polarization is Horizontal (H), IF Channel is 1, and for the Center Frequency, I've entered the highest among 8 channels at 2096 megahertz. I've also tried 1284 megahertz, which corresponds to Channel 1, but I'm unsure about what to enter on this page. I'm not receiving any signal, and everything is properly connected and wired. Additionally, it's worth noting that the TechniRouter uses a Sat-CR single-cable solution.