Problema Scan ITALY

Paese italiano, discussione sul prodotto GTMEDIA

Moderators: admin, GTMedia Team

Post Reply
Comandante99pro
Posts: 3
Joined: Mon May 23, 2022 10:30 am

Problema Scan ITALY

Post by Comandante99pro »

Salve, ho installato il decoder GTMEDIA V8 UHD facendo anche l'ultimo aggiornamento
ma nel momento in cui vado a ricercare i canali, non vengono rilevati
Uso il satellite HotBird 13, il segnale è del 60%, la qualità pari a 0%

La card che uso sarebbe questa:
Image

Delirium
Posts: 663
Joined: Sat Mar 02, 2019 6:39 am
Location: Italy

Re: Problema Scan ITALY

Post by Delirium »

Comandante99pro wrote:
Mon May 23, 2022 10:34 am
Salve, ho installato il decoder GTMEDIA V8 UHD facendo anche l'ultimo aggiornamento
ma nel momento in cui vado a ricercare i canali, non vengono rilevati
Uso il satellite HotBird 13, il segnale è del 60%, la qualità pari a 0%

La card che uso sarebbe questa:
Image
Benvenuto nel Forum ;)
Se il segnale non è rilevato - e la qualità dello 0% lo conferma - vuol dire che c' è un problema di collegamento con la parabola, che potrebbe essere non puntata correttamente, o che il ricevitore non è configurato bene.
Che tipo di LNB usi ? Universale o fornito da Sky ?
GTX Combo - V8 UHD - GT combo - V8 Finder Pro - V7 Pro - V8X - V8 Turbo - X8 - X8 combo - V8 Pro 2 - D2 DAB+

Comandante99pro
Posts: 3
Joined: Mon May 23, 2022 10:30 am

Re: Problema Scan ITALY

Post by Comandante99pro »

Delirium wrote:
Mon May 23, 2022 10:55 am
Comandante99pro wrote:
Mon May 23, 2022 10:34 am
Salve, ho installato il decoder GTMEDIA V8 UHD facendo anche l'ultimo aggiornamento
ma nel momento in cui vado a ricercare i canali, non vengono rilevati
Uso il satellite HotBird 13, il segnale è del 60%, la qualità pari a 0%

La card che uso sarebbe questa:
Image
Benvenuto nel Forum ;)
Se il segnale non è rilevato - e la qualità dello 0% lo conferma - vuol dire che c' è un problema di collegamento con la parabola, che potrebbe essere non puntata correttamente, o che il ricevitore non è configurato bene.
Che tipo di LNB usi ? Universale o fornito da Sky ?

Ciao grazie per il benvenuto e per avermi risposto
Ti mando alcune foto delle impostazione che ho "provato" a modificare
Comunque universale LNB
Image
Image

Comandante99pro
Posts: 3
Joined: Mon May 23, 2022 10:30 am

Re: Problema Scan ITALY

Post by Comandante99pro »

Comunque, dovrebbe essere puntata correttamente in quanto ho usato un APP in cui mi dava le "coordinate" per immetterla nella giusta direzione.

Delirium
Posts: 663
Joined: Sat Mar 02, 2019 6:39 am
Location: Italy

Re: Problema Scan ITALY

Post by Delirium »

Non arriva segnale al ricevitore.
Se l' antenna è puntata correttamente, ma le App non sono il massimo, perchè la precisione deve essere al top, prova a controllare gli attacchi da una parte e dall' altra.
GTX Combo - V8 UHD - GT combo - V8 Finder Pro - V7 Pro - V8X - V8 Turbo - X8 - X8 combo - V8 Pro 2 - D2 DAB+

STRETCH
Posts: 3641
Joined: Mon Jan 09, 2017 2:31 pm
Location: West Midlands UK

Re: Problema Scan ITALY

Post by STRETCH »

Have a look at "dishpointer" put in your area code and put in the satellite you wish to tune in "13e".
Put the "x" onto the spot were you have your dish, the information, should give you were your dish should be pointing, what angle your dish should be at etc.
Just looking at your photo, the signal looks low for that satellite.
If you have a portable TV, and it is safe to do so, get as near to your dish, with your receiver, plus with a spanner, you will have to adjust the dish.
With out undoing any nuts etc, with your hand, move the dish left / right and up / down, while looking at the TV screen, to see if you signal goes up or down.
Then get the spanner out, to adjust the dish to get the best signal, you will only have to move the dish a little, also check the skew of the lnb, again this info will be on "dishpointer).
If you get lost, just post again.

Den

jackino40
Posts: 1
Joined: Tue Aug 02, 2022 10:58 am

Re: Problema Scan ITALY

Post by jackino40 »

Buongiorno,
ho lo stesso identico problemo, ho il GTmedia V7pro da un anno circa e non ho mai avuto problemi, ieri improvvisamente mi si é bloccato un paio di volte, l'ho spento, ho fatto una nuova ricerca ed ora mi accade la stessa identica cosa, non trova nulla e non ha alcun segnale dalla parabola

STRETCH
Posts: 3641
Joined: Mon Jan 09, 2017 2:31 pm
Location: West Midlands UK

Re: Problema Scan ITALY

Post by STRETCH »

Switch off the receiver, check all connections/cable etc, if all is OK, switch on the receiver, what happens next, do you get a green light, what is in the display window.
Check the HDMI cable from the receiver to the TV, if you have another one try that.

Den

Post Reply

Return to “Italia”