V7 PRO support Unicable 2.0
Moderators: admin, GTMedia Team
V7 PRO support Unicable 2.0
V7 PRO support Unicable 2.0, new firmware support, if you are interested, you can PM me
FREESAT brand change GT MEDlA
Re: V7 PRO support Unicable 2.0
Bonjour,
je viens de mettre à jour mon décodeur GTMEDIA V7 Pro avec la dernière su 14/09/2022 mais je n'ai toujours pas les chaines gratuites de la TNTSat Française sur Astra 19E. Je ne sais pas à quoi sert cette mise à jour pour support "Unicable 2.0" ?
Pouvez-vous m'en dire plus!
Merci.
Philo
je viens de mettre à jour mon décodeur GTMEDIA V7 Pro avec la dernière su 14/09/2022 mais je n'ai toujours pas les chaines gratuites de la TNTSat Française sur Astra 19E. Je ne sais pas à quoi sert cette mise à jour pour support "Unicable 2.0" ?
Pouvez-vous m'en dire plus!
Merci.
Philo
Re: V7 PRO support Unicable 2.0
I thought the Unicable 2.0 protocol was being implemented and not going to replace something.
I'll explain better:
I have a motorized system with different satellite positions stored (DiSEqC1.2 in Motor setup) in the V7 Pro.
I updated to the latest firmware and imported the my "User DB". The channel list is been imported but the DiSEqC Motor settings for each satellite were not.
About the unicable 2.0, I don't have a Dcss lnb, so I can't test it.
Before updating the firmware:
After updating the firmware and importing my "User DB":
I'll explain better:
I have a motorized system with different satellite positions stored (DiSEqC1.2 in Motor setup) in the V7 Pro.
I updated to the latest firmware and imported the my "User DB". The channel list is been imported but the DiSEqC Motor settings for each satellite were not.
About the unicable 2.0, I don't have a Dcss lnb, so I can't test it.
Before updating the firmware:
After updating the firmware and importing my "User DB":
Re: V7 PRO support Unicable 2.0
Within the (LNB Installation) you can move your setting back to the (Universal(9750-10600).
This is where the system falls down, you save your channel/ system details to USB before upgrade, then when you reinput your details the receiver DOES NOT put in the Diseqc 1.2 details, you then have go through each satellite in turn to put to the correct signal levels.
With you using the (diseqc 1.2) could mean that your dish is not aligned correct, may mean just moving a very little around the pole left/right, or just undo the nut on the left, then do up the one on the right, then you will then be able to use USALS.
Check (Dish Pointer), put in your post code, and one of the satellites you view, this will then give you your (Long/Lat).
Den
This is where the system falls down, you save your channel/ system details to USB before upgrade, then when you reinput your details the receiver DOES NOT put in the Diseqc 1.2 details, you then have go through each satellite in turn to put to the correct signal levels.
With you using the (diseqc 1.2) could mean that your dish is not aligned correct, may mean just moving a very little around the pole left/right, or just undo the nut on the left, then do up the one on the right, then you will then be able to use USALS.
Check (Dish Pointer), put in your post code, and one of the satellites you view, this will then give you your (Long/Lat).
Den