GTC recording does not start on stand-by
Moderators: admin, nzl229, GTMedia Team
GTC recording does not start on stand-by
when a recording has been programmed and put into stand-by mode it does not start the recording.
it only works when it is on the device
it only works when it is on the device
-
- Posts: 548
- Joined: Thu Nov 29, 2018 12:50 am
Re: GTC recording does not start on stand-by
You might try this.... You cannot use the wake up time as the start recording time as it will not record on Standby. You need to set the box to wake up at least a few minutes (3-5 minutes) for bootup, etc. before the set recording time. Same for shut down, you need to set the end recording time at a time before the time you set for sleep time if you are doing that also.
Good Luck and Beers to you !
Good Luck and Beers to you !
Re: GTC recording does not start on stand-by
Hi i have the same Problem, have tested it as you write it, but its not starting...
Couldnt record anything via PVR and Timer..
Couldnt record anything via PVR and Timer..
Re: GTC recording does not start on stand-by
hi Captain Ron, what you comment does not work on stand-by does not start the scheduled recording. it only starts if it is on
any other suggestions? Thank you
any other suggestions? Thank you
Re: GTC recording does not start on stand-by
Can nobody help with this prob?
Any software that helps??
Any software that helps??
Re: GTC recording does not start on stand-by
Too Bad no help from the softwareprogrammers??
Re: GTC recording does not start on stand-by
Access to a booking(recording or watching) from standby is currently not supported, and the GTMedia team will consider adding this feature.
Re: GTC recording does not start on stand-by
That would be great, what when we bring the box not in stand by, we bring it in out modus..?
Re: GTC recording does not start on stand-by
Did you find the Problem and a Solution??
Re: GTC recording does not start on stand-by
No Update no help for this Problem??
Re: GTC recording does not start on stand-by
The new upgrade will be released this month, but still need to wait
Re: GTC recording does not start on stand-by
Ok, nice to hear!