usals
Moderators: admin, GTMedia Team
Re: usals
Some information which should help you set your receiver to USALS.
Menu / Install / Satellite List / On the left of the screen, you should have a list of Satellites, with a Satellite which should be (High-Lighted).
The information about this satellite will be on the Right, with the Arrows on the Remote move the Curser over to the Right, then Move the Curser
Down to (Motor-Setup), again with the arrows, move to the Right until you see (USALS), at the bottom of the screen you should see a Green Circle
(Set Location), Press the Green button on the remote, what comes to the screen, under (Motor Antenna) will be ( Longitude / Latitude).
(Lets say, you are in (PARIS) your Longitude would be (002.35W) / Latitude would be (48.85N), then Move the curser Down to Save, Press OK.
Then Exit out, these details will have to be put against each satellite that you set up.
Hope this helps.
Den
Menu / Install / Satellite List / On the left of the screen, you should have a list of Satellites, with a Satellite which should be (High-Lighted).
The information about this satellite will be on the Right, with the Arrows on the Remote move the Curser over to the Right, then Move the Curser
Down to (Motor-Setup), again with the arrows, move to the Right until you see (USALS), at the bottom of the screen you should see a Green Circle
(Set Location), Press the Green button on the remote, what comes to the screen, under (Motor Antenna) will be ( Longitude / Latitude).
(Lets say, you are in (PARIS) your Longitude would be (002.35W) / Latitude would be (48.85N), then Move the curser Down to Save, Press OK.
Then Exit out, these details will have to be put against each satellite that you set up.
Hope this helps.
Den