GTMEDIA D2 Firmware(13/06/2019)

This zone is for some friends to experience new firmware or new box.

Moderators: admin, GTMedia Team

Post Reply
juergenoberau
Posts: 2
Joined: Wed Aug 28, 2019 11:29 am

GTMEDIA D2 Firmware(13/06/2019)

Post by juergenoberau » Wed Aug 28, 2019 11:34 am

I alway get the message no File on SD Card... it shows the folder but not the extracted file

Wat to do

anne12
Posts: 1
Joined: Wed Aug 28, 2019 8:22 pm
Contact:

Re: GTMEDIA D2 Firmware(13/06/2019)

Post by anne12 » Wed Aug 28, 2019 8:24 pm

I have the same problem, what could be going on?

juergenoberau
Posts: 2
Joined: Wed Aug 28, 2019 11:29 am

Re: GTMEDIA D2 Firmware(13/06/2019)

Post by juergenoberau » Mon Sep 02, 2019 2:06 pm

juergenoberau wrote:
Wed Aug 28, 2019 11:34 am
I alway get the message no File on SD Card... it shows the folder but not the extracted file

Wat to do

afer fiew days no reacton from this company...

digitalfranz
Posts: 1
Joined: Fri Sep 06, 2019 8:28 am

Re: GTMEDIA D2 Firmware(13/06/2019)

Post by digitalfranz » Fri Sep 06, 2019 7:42 pm

Hi everybody!

I was trying to updare D2 FW...
BUT
instructions says--> "USB connection to the computer---press the Menu button at the same time, enter the upgrade interface and release the button"

What does it means? I have connected radio to pc, pressed menu button (same time...what means?) because i have tried to press menu button when inserted USB to PC (radio already connected, of course) BUT my PC doesn'ty enter in D2 mobile disk....where (if) am i wrong with sequence?

Thanks 4 reading and possible explanation...

RMSCOM
Posts: 1
Joined: Thu Aug 29, 2019 12:01 pm

Re: GTMEDIA D2 Firmware(13/06/2019)

Post by RMSCOM » Mon Sep 16, 2019 9:28 pm

Hi,
I was having the same problem until I tried pressing the "Func" button rather than "Menu" - then it worked!

Revised instructions:
1. Ensure radio is OFF
2. Connect USB cable to radio and PC
3. Press and hold FUNC button and while doing that, switch radio on (to "Music")
4. Radio will display message to confirm we are now in firmware update mode
5. Look for the new connected USB drive on your PC
6. Drag & drop the firmware update file onto this drive and wait until it has copied over completely
7. When the copy has finished, EJECT the USB drive
8. Radio will display a message showing the firmware update is in progress and then it will reboot
DONE :D

Post Reply