Hi everyone,
I'm having a problem with my GTmedia v8 Finder Pro. I can only store satellites west to 45 degrees and east to 68.5 degrees. The following satellites get an "out of range" message.
How can I fix this?
Thanks for your help.
HELP GTmedia v8 Finder Pro
Moderators: admin, GTMedia Team
-
Feralkiwi
- 网站管理员
- Posts: 9251
- Joined: Fri Aug 12, 2016 6:51 am
- Location: New Zealand
Re: HELP GTmedia v8 Finder Pro
The out of range error was with the finder.
viewtopic.php?p=155465#p155465
Also check that you have the correct longitude set for the satellite.
Most ku band motors can use DiSEqC motor control as well.
Note the position number is saved in both the box and the motor.
To save a position in the box and NOT incorrectly in the motor, save in the box with the LNB cable off.
You could save the DiSEqC position with the other box and then move to it with this box.
Owen
viewtopic.php?p=155465#p155465
Also check that you have the correct longitude set for the satellite.
Most ku band motors can use DiSEqC motor control as well.
Note the position number is saved in both the box and the motor.
To save a position in the box and NOT incorrectly in the motor, save in the box with the LNB cable off.
You could save the DiSEqC position with the other box and then move to it with this box.
Owen
Dishes; 2x3m, 4.1m, 10+ ku, 2 movers, USARLS. V8Pro2, GTC, Finder2 + Pro1, Finder-Meter V8X / UHD V7Pro GT/X Combo, Freesat V8Ultra. Sats 100.5E to 177W. I'm a Sat hobbyist who helps out.
Who is online
Users browsing this forum: All compatible Bots and 1 guest