Problema segnale sat dopo upgrade a v7pro M.rs

Paese italiano, discussione sul prodotto GTMEDIA

Moderators: admin, GTMedia Team

Cornicipe
Posts: 6
Joined: Fri Aug 11, 2023 2:27 pm

Problema segnale sat dopo upgrade a v7pro M.rs

Post by Cornicipe »

Buona sera a tutti e scusate se vi disturbo.
Ho un v7pro che ha funzionato normalmente finora col fw di settembre 22. Oggi ho caricato il fw M.rs e ho aggiunto la lista dei canali di GIORGIOTEAM però il dispositivo non "sente" più il segnale satellitare, anzi mi dà potenza al 90% ma qualità 0% quando fino a poco prima avevo il 70% di qualità e i canali venivano visualizzati correttamente.
Mi potete aiutare? Qualcuno avrebbe un suggerimento da farmi provare?
Grazie mille a tutti e ciao.

gbiafora
Posts: 72
Joined: Mon Feb 21, 2022 4:28 pm

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by gbiafora »

Metti l'ultimo firmware M.rs 6/7/23, fai ricerca canali e vedi se tutto funziona poi prendi la lista canali per il firmware M.rs perché se non sbaglio ne esistono
2 versione

STRETCH
Posts: 4082
Joined: Mon Jan 09, 2017 2:31 pm
Location: West Midlands UK

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by STRETCH »

Did you save your channel list to USB, before putting adding the new channel list.
Is your dish fitted with a motor, if so you will have to put in your LAT/LONG details.
Check your lnb settings etc.
You may have to start again, save the new channel list to USB.
Connect every thing up as a new install, then check that you can get a signal from the satellite that you were viewing.

Den

Cornicipe
Posts: 6
Joined: Fri Aug 11, 2023 2:27 pm

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by Cornicipe »

rifatto tutto da capo, vedo solo i canali di alcuni transponder (mediaset, la7, rai premium/scuola) mentre i vari rai (1/2/3 ecc... e tutti i regionali) non sono visibili e mi dà sempre qualità 0%
la parabola non è motorizzata e ho caricato le liste aggiornate di GIORGIO team (viewtopic.php?f=45&t=29441)

Cornicipe
Posts: 6
Joined: Fri Aug 11, 2023 2:27 pm

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by Cornicipe »

e anche altri canali di altri transponder non vanno (tv8, nove, vh1 per fare degli esempi)

STRETCH
Posts: 4082
Joined: Mon Jan 09, 2017 2:31 pm
Location: West Midlands UK

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by STRETCH »

What satellite are you pointing at, some of your channels are at 5w.
Where are you located, what size dish do you have, you may have to tweak the dish a little, or skew the lnb also, to bring in some of the transponders.

Den

Cornicipe
Posts: 6
Joined: Fri Aug 11, 2023 2:27 pm

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by Cornicipe »

thank you Den
the dish points at hotbird 13 but I don't know the size and I cannot tweak it because it's on the roof of the building and I do not have an easy access to it.
I can add an information: 2 days ago the transponder on which there are most of RAI channels (1 2 3 etc) became visible and also mediaset had an increase in the received quality ... maybe it's been an increase in the power of the transmissions?
Channels from the Sky bouquet have never been seen instead...

Cornicipe
Posts: 6
Joined: Fri Aug 11, 2023 2:27 pm

Re: Problema segnale sat dopo upgrade a v7pro M.rs

Post by Cornicipe »

the dish is on the eastern alps, in a holiday house near Belluno, and since last winter I received properly all channels that now I cannot see instead