how add eutelsat 25 ?

[eric738]

GM

does anybody can help me to add eutelsat 25 on setup step by step or send url to tuto?

thank in advance

Eric

[Feralkiwi]

Hi

Press Menu / right arrow / down arrow then OK to select "satellite list"
You will see the color buttons are allocated functions as listed along the bottom.
Press Green for "More"
Now there is the yellow button for "ADD"
Press yellow and you can now type the name of your sat.
The key entry is the same as on a Phone.
Press red for caps and the 3 twice, red again for lower case, then 8 twice for the u, then right arrow to move to the next letter so you can press 8 again for t.
When you have the name press down arrow and type the longitude for the sat and then Yellow for OK and save.

Press "OK" to mark this sat for use. You will see a tick beside it. No tick and it will not come up in other options.
Now press yellow for setup.
Press left or right arrows to get your sat in the satellite window.
Now you will need to set up the frequency for your LNB, normally 5150 for big mesh dish C band and 9750/10600 for small KU dishes.
If you have switches between you many dishes set the switch setting. DiSEqC 1.0 is used for up to 4 dishes. If you have only one dish leave these "disabled"
22kHz is used to switch between two dishes / LNB's. If you use 9750/10600 this is done automatically.
Leave polarity as auto.
When set press exit.

After that you can do a scan / search using the blue button.

Good luck.

Owen

[eric738]

Thank a lot i will follow step and back to said if its ok .

Eric