That set up should not work as when the instructions for the ku motor dish are sent, the 22kHz tone used for the data transmission will switch the 22kHz switch.owhite47 wrote: ↑Wed Jul 15, 2020 9:45 amI don't have a disqc switch, just a 22k tone switch , on for cband off for ku
10ft cband western arc
4ft ku motorized western arc.
v7hd works fine
3v8novas works fine
XXXXX works fine
XXXXX work fine.
same room same cable.
no matter how long i leave it off it doesn't have a signal.
我沒有 disqc 開關, 只是一個 22k 音開關, 為 ku 關閉 cband
10 英尺 cband 西弧
4 英尺 ku 機動西弧。
v7hd 工作正常
3v8novas 工作正常
XXXXX 工作正常
XXXXX 工作正常。
同一房間相同的電纜。
無論我離開多久, 它也沒有信號。
Edit by the rule.
It must be a fluke that the other units worked on that set up. When the switch sees the 22kHz tone it will switch the power over to the C band dish for each "Bit" of data sent.
You will need to use a DiSEqC switch or re set up to this cable setting.
Box--------------Ku Motor-------22kHz switch "Off"--------- Ku LNB.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . \--ON--------C band LNB
As the motor commands are not sent with the antenna setting for the C band, the Ku dish will not move.
This will hold power on the mover and it will get the move commands with no interruption from the switch.
How you ever got this working with the 22kHz switch before the motor is beyond me!!.
Owen